Lubrication; Optional Accessories; Protecting The Environment - DeWalt D25960 Mode D'emploi

WARNING: Ensure that the cutting
edge does not show discolouration
caused by too much pressure. This may
impair the hardness of the accessory.
For the best results only use sharp chisel bits.
Sharpening chisel bits frequently will guarantee
long life of the chisel bits and the best performance
results.
GRINDING
Refer to figure 5 for the types of chisels to use with
this tool.
Grind the chisels on grinding discs with continuos
water flow. Refer to figure 6 for the appropriate
angles of the following chisels:
k. pointed chisel
l. flat chisel
m. wide scaling chisel
n. clay spade
FORGING
For forging:
Heat the chisel to 850–1050°C (light red–yellow).
To harden the chisel again:
• Heat the chisel to 900°C and quench it in oil.
• Then place the chisel into the oven for 1 hour at
320°C (color is light blue).

Lubrication

Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often
as dirt is seen collecting in and around
the air vents. Wear eye protection when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D WALT products once they have
E
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
D WALT office at the address indicated in this
E
manual. Alternatively, a list of authorised D
repair agents and full details of our after-sales
service and contacts are available on the Internet at:
www.2helpU.com.
EN GL IS H
WALT, have
E
WALT product
E
WALT
E
29