Scale Operation; Power Options; Battery Power; Audible Beeps - Welch Allyn 6702 Mode D'emploi

Scale operation

Power options

The scale can be used with battery power or with AC power.
Press the power button to turn on the scale. When connected to AC power, the green
AC power light illuminates.

Battery power

Press
The scale automatically turns off after 45 seconds of non-use when operating on battery
power.
The LOW BATTERY indicator illuminates when the battery power is low.
bAttrY displays when the batteries are unable to properly power the scale.
Replace the batteries when either of these messages are displayed.
AC power
When plugged in, the scale continuously runs on AC power automatically, depending on
your settings.
To disconnect the scale from AC power, either remove the power adaptor from the wall
or the side of the scale. Make sure to position the scale so that it can be easily
disconnected from AC power.
The scale switches to battery power when AC power is not present.

Audible beeps

The following beeps occur when using the scale.
Note
CAUTION Use only size D disposable alkaline batteries. The use of any
other battery will void the warranty.
to turn on the scale.
These beeps do not occur if the beeper option has been disabled in the
setup menu.
11