Philips HF3490 Mode D'emploi page 15

Problem
The light wakes me too
late
The lamp flashes.
The iPod/iPhone was
not charged after I
placed it in the iPod/
iPhone station.
The music played by the
iPod/iPhone does not
come out of the speaker
of the Wake-up Light.
The alarm sound with
the iPod/iPhone music
did not work.
The controls on iPod/
iPhone did not work.
Solution
Perhaps the appliance is positioned at a lower level than your head.
Make sure the appliance is located at a height at which the light is not
blocked by your bed, duvet or pillow. Also make sure the appliance is
not placed too far away.
Perhaps there has been a power failure. It is normal for the lamp to
flash after a power failure.
Perhaps the appliance is not suitable for the voltage to which it is
connected. Make sure that the voltage indicated on the appliance
corresponds to the local mains voltage.
Perhaps you did not place the iPod/iPhone properly in the iPod/iPhone
station. Make sure you place the iPod/iPhone correctly in the iPod/
iPhone station. See chapter 'Using the appliance', section 'Using the
iPod/iPhone'.
Perhaps you had not placed the Wake-up Light properly on the base.
Make sure you place the Wake-up Light properly on the base. Make
sure that the mains cord and/or the antenna are not stuck between
the base and the Wake-up Light.
Perhaps the plug of the Wake-up Light is not inserted properly in the
wall socket. Put the plug properly in the wall socket.
Perhaps there has been a power failure.
Perhaps you did not place the iPod/iPhone properly in the iPod/iPhone
station. Make sure you place the iPod/iPhone correctly on the iPod/
iPhone station. See chapter 'Using the appliance', section 'Using the
iPod/iPhone'.
Perhaps you set a sound level that is too low. Set a higher sound level.
See chapter 'Using the appliance', section 'Radio/volume.
Perhaps the playlist in your iPod/iPhone is empty. Make sure you put
your favorite music in the playlist.
Perhaps you did not select the iPod/iPhone as the alarm sound. Select
the iPod/iPhone as alarm sound when you set the alarm. See chapter
'Using the appliance', section 'Setting the alarm sound'.
Perhaps the iPod/iPhone was not working properly. Try to restart the
iPod/iPhone.
EnglisH
15