Philips HF3490 Mode D'emploi page 14

EnglisH
14
Problem
The lamp does not go
on when the alarm goes
off.
The lamp does not go
on right away when I
switch it on.
I do not hear the alarm
sound when the alarm
goes off.
The radio does not
work.
The radio produces a
crackling sound.
The alarm went off
yesterday, but it did not
go off today.
The alarm did not go off
9 minutes after I pushed
the control lever down
to snooze.
The light wakes me too
early.
Solution
Perhaps you set a light intensity level that is too low. Increase the light
intensity level.
Perhaps you switched off the alarm function by setting the control
lever to the top position. To switch on the alarm function, set the
control lever to the middle position
Perhaps the appliance is defective. Contact the Philips Consumer Care
Centre in your country.
It takes approx. 1 second for the lamp to go on. This is normal, the
lamp needs to heat up.
Perhaps you set a sound level that is too low. To set a higher sound
level, see chapter 'Using the appliance', section 'Radio/volume'.
Perhaps you switched off the alarm function by setting the control
lever to the top position.
If you selected the radio as the alarm sound, the radio may be
defective. Switch on the radio after you switch off the alarm to check if
the radio works. If it does not work, contact the Philips Consumer
Care Centre in your country.
The radio may be defective. Contact the Philips Consumer Care
Centre in your country.
Perhaps the broadcast signal is weak. Move the middle function
selector (SET) up or down to adjust the frequency and/or change the
position of the antenna by moving it around. Make sure you have
unwound the antenna completely.
Perhaps you switched off the alarm function by setting the control
lever to the top position.
Perhaps you set a sound level and/or light intensity level that is too low.
Set a higher sound and/or light intensity level.
Perhaps there was a power failure that lasted more than approximately
15 minutes. In this case the appliance has remembered all settings
except the clock time. The clock time therefore flashes on the display.
Set the correct clock time.
Perhaps you pushed the control lever down with so much force that it
jumped to off position.
Perhaps you set the volume level to 0.
Perhaps the light intensity level you have set is not appropriate for you.
Try a lower light intensity level if you wake up too early. If light intensity
1 is not low enough, move the appliance further away from the bed.