Programming The Light - weinor BiLine Combio-868 MVLED Instructions De Montage Et D'installation

BiLine Combio-868 MVLED/ MLED
6.3

Programming the light

1. The light alternates between 100% and 50% power.
2. Press the learning key on the hand transmitter for 2 seconds.
This step does not apply to the unidirectional hand transmitter (Remoto).
The light is currently in learning mode.
3. On the hand transmitter, select the channel you want to use to program the lighting (e.g.
Channel 2).
4. Within the first second during which the lighting brightens to 100% power, briefly press the
UP key. The receiver confirms this command by briefly switching off and then on.
5. Then, within the first second during which the lighting dims to 50% power, briefly press the
DOWN key. The receiver confirms this programming by briefly switching off.
Initialise any other transmitters or sensors that are being used.
Finally, check that the awning and lighting have been successfully programmed.
Item number 116692-0000
Version 2 15.11.2013
We reserve the right to make technical
changes
Page 11/28
Assembly and installation instructions