Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BiLine Combio-868 MVLED/ MLED
4
Getting started
4.1
Pre-programmed system
The system is usually supplied pre-programmed. This means that all the components can be
controlled with the hand transmitter supplied. In this case, once the system is assembled and
installed, you can immediately start using the remote-receiver and check that all the functions
are working properly.
4.2
Unprogrammed system
On rare occasions or if servicing has been carried out, however, the system will need to be
programmed on site. This is done by pairing up the hand transmitter and remote-receiver and
setting them to various functions (see Section 3).
4.3
Checking the functions
Once all the installation work is completed, you will need to check that the system is working
properly and that the individual components are paired.
What to check
•
Are the awning and
Valance Plus working?
•
Does the awning extend
fully first, followed by the
Valance Plus?
•
Does the Valance
Plus retract fully first,
followed by the awning?
•
Is the light working?
•
Can the light be dimmed?
•
Are all the sensors (if they
are being used)
programmed to the correct
direction?
Table 2: Checking the functions
If the components do not react as expected, check the table below to locate the likely cause.
Item number 116692-0000
Version 2
15.11.2013
How to do it
Briefly press DOWN key
Briefly press UP key
Double-click
Press and hold the UP key
Press and hold the DOWN
key
•
Simulated "wind" on the
sun/wind (or
sun/wind/rain) sensor
•
Shake the drop profile (if
an Agido product
protection sensor is
installed)
We reserve the right to make technical
changes
Page 8/28
Assembly and installation instructions
Outcome
Awning extends fully, followed
by Valance Plus (to sun
protection position).
Valance Plus retracts fully,
followed by awning.
The light switches on.
The light gets brighter.
The light gets darker.
Awning retracts
Awning retracts
Publicité
Chapitres
Table des Matières
Dépannage
