Programming; Programming The Remote-Receiver; Programming The Awning - weinor BiLine Combio-868 MVLED Instructions De Montage Et D'installation

BiLine Combio-868 MVLED/ MLED
6

Programming

6.1

Programming the remote-receiver

The system is usually supplied pre-programmed. Therefore, when the system is
delivered, all the components can be controlled with the hand transmitter supplied. On
rare occasions or if servicing has been carried out, however, the system will need to be
programmed on site. This is done by pairing up the hand transmitter and remote-receiver
and setting them to various functions.
6.2

Programming the awning

In the case of receivers that have already been electrically installed, briefly disconnect the
1.
power supply immediately before programming.
2. Start programming mode: within 5 minutes of disconnecting the power supply, press the
LEARN key (1) for 2 seconds on the hand transmitter. The remote-receiver then enters
programming mode for about 2 minutes. During this time, the awning moves up for 4
seconds and then down for 4 seconds.
3. Immediately after the awning starts moving up (within the first second), press the
key on the hand transmitter. The receiver confirms the command by briefly stopping the
awning and then moving it up further. If the receiver does not confirm the command, simply
repeat this step on one of the next cycles.
4. Immediately after the awning starts moving down (within the first second), press the
DOWN key on the hand transmitter. The receiver confirms this step by leaving programming
mode; the sun protection stops moving.
5. If integrated lighting is connected to the Combio-868 MVLED/MLED, the light programming
mode will start automatically. Now program the light by taking the following steps. For
designs with no light, stop programming mode by pressing
the STOP key.
Item number 116692-0000
Version 2 15.11.2013
1
We reserve the right to make technical
changes
Page 10/28
Assembly and installation instructions
UP