AEB Leonardo 175 Mode D'emploi Et Garantie page 22

Original Configuration
The "Leonardo" is supplied configured according to the parameters given in the chart below. Considering that
not all vehicles have the same characteristics, it is necessary to make sure each time that the parameters are
correct. If, after the modification of the various parameters, the [MEMORY ERASE] function is used by means
of the laptop computer or the hand - held tester, the parameters are automatically returned to the original
configuration.
Ignition type or number of cylinders
Type of RPM signal
Type of petrol to alt. fuel switchover
Number of RPM for petrol to alt. fuel switchover
Fuel overlap duration
Type of alt. fuel level indicator
T.P.S. type
Lambda Sensor type
Lambda Sensor reading delay (Open - Loop)
Type of Oxygen Sensor simulation
Yellow wire utilisation
PETROL TO ALTERNATE FUEL SWITCHOVER
Switchover temperature
PLEASE NOTE: if the temperature sensor is not connected to the "Leonardo" , this function has no
effect on the fuel switchover
Overrev option
Automatic switchover to petrol with low alt. fuel level
ACTUATOR
Option default lock
Idle opening steps over default
Idle closing steps under default
Out - of - idle opening steps over default
Out - of - idle opening steps under default
Full throttle option
T.P.S.
Idle hysteresis
CUT - OFF
Cut - Off option
O2 SENSOR INOPERATIVE
OXYGEN SENSOR RICH FOR TOO LONG
OXYGEN SENSOR LEAN FOR TOO LONG
Pag. 22
WARNING!
VEHICLE CONFIGURATION
DUAL COIL
STANDARD
T.P.S. DECELERATION
2000 rpm
0,4 seconds
A.E.B.
LINEAR 0 ÷ 5 V
0 ÷ 1 V
5 seconds
STANDARD SQUARE WAVE
INJECTION DISABLING
OPTIONAL CONFIGURATIONS
15°C
DISABLED
DISABLED
DISABLED
25
25
40
40
DISABLED
0,14 V
DISABLED
DIAGNOSIS
DISABLED
DISABLED
DISABLED
English
Is175 Rev. 240102 - 2