Technical Specification; Noise Level; Warranty - RM Speedy-Rain 401 Instructions D'utilisation

Les langues disponibles

INSTRUCTION AND MAINTENANCE MANUAL

INTRODUCTION (Part I)

The irrigation equipment manufactured by RM will provide excellent service when used correctly. We recommend

reading these Operating and Maintenance Instructions carefully. The "Speedy Rain" Series 401 Turbine has

been tested to work at a minimum pressure of 3.5 bar and a maximum of 8 bar. If the machine is used at higher

pressure, manufacturer declines any and all liability for any damage caused. If the machine has to be operated

at more than 8 bar, please contact our Technical Assistance Department. The machine should be supplied with

water using a rubber hose with a minimum inside diameter of 32 cm.

Water supply can be with an electric pump, motor pump, water mains, etc.

At the end of hose rewinding, the hose drive mechanism shuts down but water will continue to come out of the

rain gun. The manufacturer can supply an optional kit called "Acquastop" which is shut off the water supply to the

machine when the hose has been rewound.

All Series 401 Turbine Speedy Rain irrigation systems are equipped with a wormscrew hose guide for perfect

hose rewinding.

TECHNICAL SPECIFICATIONS

Due to its very nature, the machine is not noisy.

- SAFETIES

The machine is complying with European Union Directives:

EEC 89/392 dated 16/6/89; EEC 91/368 dated 20/6/91; EEC 93/44 dated 14/6/93; EEC 93/68 dated 22/7/93

(machine directive); EEC 89/391 (work site safety and hygiene).

NOTICES

This Operating and Maintenance Manual is an integral part of the sprinkler system and must accompany the

machine whenever sold to another owner or transferred among farms.

The manual should be kept carefully, read and placed readily at the disposal of all persons involved with it.

In tune with the overall design of the machine, this manual has been prepared in complete compliance with

European Union directives-viz., EEC 89/392, EEC 91/368, EEC 93/44 and EEC 93/68 (Machinery Directives).

Furthermore, the manual has been prepared in compliance with the latest regulations and legislation

concerning hygiene and safety in the work place published under EEC Directive 89/391.

All sprinkler irrigation systems manufactured by RM are guaranteed for one year from the date of purchase.

This warranty covers only the replacement without charge or repair of any parts with fabrication or material

defects.

The following are not covered by warranty:

Defects caused by improper use or use not complying with the Operating Instructions delivered with every

Sprinkler irrigation system, accidental damage caused by outside agents; improper handling.

Any tampering with the machine or its safety devices can make this warranty null and void.

12/48

Table des Matières

Chapitres