Technical Data - juwel 100/60 Easy Fix Notice De Montage

Frühbeet 100/60 Easy-Fix
instructions, before using the cold frame. Non-compliance
with these instructions can lead to injuries or damage to the
cold frame.
The directions are based on the standards and rules which
apply in the European Union. In other countries, please
observe the country-specific directives and laws.
Keep the instructions for further use. If you pass on the
cold frame to a third party, it is essential to give these
instructions with it.
SAFEtY
Use for the intended purpose
The cold frame has been designed exclusively for the
purpose of growing plants. It is exclusively intended for
private use and is not suitable for the commercial sector.
Use the cold frame only in the manner described in these
directions. Any other use is not considered to be in accor-
dance with the intended purpose and can lead to damage
to property or even to personal injury. The manufacturer
or dealer will not accept any liability for damage caused
by incorrect use or use that is not in accordance with the
intended purpose.
Safety instructions
WARNING!
Danger of suffocation!
Children playing with the packaging film can
get caught in it and suffocate.
• Do not let your children play with the packaging foil.
WARNING!
Risk of injury!
If there is a strong wind, the lid can fall on your
fingers or the cold frame can be torn away and
this can cause damage to property or personal
injury.
• Set up the cold frame in a place where it will
be sheltered from the wind.
• Close the lid when there is a strong wind or
storm. Hook the vent opener into the front
wall, so that the lid cannot be opened again.
• The lid may only be opened and fixed in place when
there is no wind.
• Additional security may be required in wind prone
areas.
ASSEMBLY
CAUtIoN!
Risk of damage!
The walls and the lid of the cold frame are break-
able and can be damaged or destroyed if you do
not assemble the cold frame with the necessary
care.
• Assemble the cold frame carefully and on
a suitable base.
• 1-2 people should assemble the item. We recommend
you to wear protective gloves during assembly.
USE
NotE!
Risk of damage!
4
Handling the cold frame or your plants incorrectly can
cause the plants to die or mould spores to form in it.
• Open and fix the lid in position during strong sunlight.
Close the lid again when it becomes cooler (drop in
temperature to less than 10 °C).
• Use a source of heat, e.g. a heat lamp, when outside
temperatures are low or when there are several days
with only little sunlight.
• Water the plants in the morning.
• Take care that the seeds you wish to plant are suitable
for greenhouses and cold frames.
The highly heat-insulating hollow-chamber plates absorb
the incident solar radiation and convert it into heat. The
heat helps your plants grow better.
• In the summer when temperatures don't drop below
15 °C even at night time, you can take the lid off com-
pletely or simply disassemble the cold frame and put it
away in a protected place until it is next used.
• When inserting the ground anchors that are included in
the content into the ground, insert them as diagonally as
possible so that the cold frame will be anchored securely.
Close the lid if there is a strong wind or storm. Hook in
the vent opener on the front wall so that the lid cannot be
opened again.
CLEANING
CAUtIoN!
Risk of damage!
Handling the cold frame incorrectly
can cause damage.
• Do not use any aggressive detergents, brushes with me-
tal or nylon bristles or sharp, rough or metallic cleaning
objects such as knives, hard scrapers or suchlike. These
can damage the surfaces.
• Use a garden hose or a watering can to wash down the
cold frame.
• Use a soft cloth to remove dirt.
StoRAGE
• Make sure that all cold-frame components are comple-
tely dry.
• Keep the cold frame in a dry place that is sheltered from
the wind.
• Store the cold frame out of reach of children, closed
securely and at a storage temperature between + 5° C
and + 20° C (room temperature).

tECHNICAL DAtA

Weight: 2,9 kg
Dimensions: ~ 100 cm x 60 cm x 40/30 cm
Article number: 20226
WAStE DISPoSAL
Disposal of packaging / cold frame
Dispose of the cold frame / packaging in accordance
with the rules and regulations that apply in your
country.
Art.-Nr. 20226