Auxiliary Controls - GE Zoneline AZ45 Manuel D'utilisation

Auxiliary controls on your Zoneline
Auxiliary Controls - Aux Set Button
While the unit is preset to what most customers prefer, the
control panel.
Cover section.
mode control and turn the unit off, then, press the red
AUX SET
Press the mode button on the control pad until the first digit
in the display shows the number corresponding to the mode
Press the +/- button to make the mode setting selection
Press "Aux Set"
* Not available on all models.
MODE 1 Smart Fan—Cooling/Heating
Press MODE
for Smart Fan
MODE HEAT
be lit.
heating or cooling mode selected "
Press the + pad to set the indoor fan to run continuously in
the heating or cooling mode selected "
Press AUX SET
SET mode, or press MODE to continue setting other
functions.
*Note:
heating mode, the fan will continue to operate for several
seconds after the heating function has stopped in order to
increase unit efficiency.
8
First Digit Second Digit
Press "Mode" Press + -
/
Smart Fan
- Cycle - Continue
Temperature
Display
Sentinel
Off On
Constant
Off On
Fan
COOL
Press the red AUX SET button to lock in the selection, and
Press "Aux Set"
First Digit Second Digit
Press "Mode" Press + -
/
Temperature
Limit
Class 2
Mode
Duct Mode *
All I2R Mode
(AZ65 Only)
Off On (Cool/Heat)
Boost Heat
(AZ65 Only)
AUX
Red
Button
Press "Aux Set"
First Digit Second Digit
Press "Mode" Press + -
/
Makeup Air 0: OFF
1: 25CFM 4: 40CFM
Mode *
2: 30CFM 5: 45CFM
3: 35CFM 6: 50CFM
Makeup Air
Disable Enable
Occupancy *
Engineering
Press +/- to match last
Revision*
digit of model number
On (Auto Change Over)
293D2203P003
49-5000355 Rev. 2