Velleman-Kit EDU10 Mode D'emploi page 6

p. 6
Run the EDU10 Startup Demo Run the EDU10 Startup Demo
• Click on "On" check box in the panel "VDD PICkit 2" to turn the EDU10 power on.
• Use the "Up" arrow to adjust the voltage to 5V.
• Now the PIC16F882 on EDU10 should be running its default "Startup" program.
Running other demos Running other demos
In the software package for the EDU10 there are several demos written in assembly and C.
You can use the PICkit 2 Programmer software to reprogram the PIC16F882 on the EDU10 board with the downloaded demo code.
You can test the board by pressing buttons SW1..SW4
and RESET (SW5). There should be following response:
SW1:
- Turn on LD7
- Show '7' on the 7-segment display.
SW2:
- Turn on LD6
- Show '6' on the 7-segment display.
SW3:
- Turn on LD5
- Show '5' on the 7-segment display.
SW4:
- Turn on LD4
- Sound is generated.
- Display all segments+dot on the 7-segment display.
RESET mode:
- LDR is programmed as light detector.
- LDR turns LED LD8 on/off depending on light.
- Potentiometer RV1 changes the display brightness.
- If NTC voltage <1V or >4V then "E" (Error) is displayed on the
7-segment display.
- UK -
USB PIC PROGRAMMER AND TUTOR BOARD