Starting Ez Setup; Using Ch Setup; Using Antenna Setup - Digital - HP SLC3760N Manuel De L'utilisateur

Setup menu Description (continued)
Picture Flip Sets the orientation of the
picture.
Standby Sets the TV mode for standby.
Mode
Language Sets the OSD menu language.
Reset Sets Setup options to the
factory preset values. Does not
change the Channel Setup,
Parental CTRL password, or
Language settings.

Starting EZ Setup

Select EZ Setup to start the first-time setup wizard.
To start EZ Setup:
1
Press Setup on the remote control.
2
Press the up or down arrow buttons to select
Setup. Press OK.
3
Select EZ Setup, and then press OK.
4
If you set the Secret No., enter your 4-digit secret
number. See "Using Parental Controls" on
page 56.
5
Follow the setup wizard instructions. For more
information, refer to "Using the First-Time Setup
Wizard" on page 23.

Using CH Setup

If the initial setup does not find all the channels, use
CH Setup to manually select the antenna and search
for each missing channel.
Setting the antenna using the Air/Cable
option
The Air/Cable option defines what type of antenna or
cable is connected to the TV input.
If channels are missing or no channels are found after
running CH Search, check your antenna connection,
and then perform CH Setup again.
52
HP MediaSmart HDTV User's Guide
Scanning for channels using the
CH Search option
The CH Search option makes the TV look for all
channels viewable from the signal cable connected to
the TV input.
1
In the CH Search menu, select Yes for Air Analog
& Digital, Cable Analog, or Cable Analog &
Digital.
2
Select Search Start, and press OK.
The scan automatically searches the selected
inputs for channels.
Removing channels using the CH
Memory option
Use the CH Memory option to remove channels from
the list of found channels. The removed channel does
not appear when using the Channel buttons.
1
Select CH Memory, and press OK.
2
Select Analog (Air), Analog (Cable), Digital
(Air), or Digital (Cable), and then press OK.
3
Select the channel, and press OK.
4
Select Skip, select On, and press OK.
On skips the channel.
■
Off does not skip the channel.
■
Using Antenna Setup – Digital
To receive air digital television signals, you need a
digital antenna. You can set the antenna configuration
through the Antenna Setting screen. Adjust for air
digital TV signal and channel strength using the
Antenna Setup – Digital option.
Signal Strength shows the current and
■
maximum signal strength.
Channel Strength, available for Digital (Air)
■
channels only, helps you adjust the direction of the
air digital antenna.