Using The Remote Control; Operating The Tv; Using Universal Remote Controls; Installing Or Replacing Remote Control Batteries - HP SLC3760N Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Using the Remote Control

Operating the TV

The remote control operates the
TV. To use the remote control,
point the remote control at the
remote control sensor window
located near the lower-right
corner of the front of the TV
display.
n
Use the remote control within a distance of
16.4 feet (5 meters) from the front of the TV
remote control sensor window and at the
maximum horizontal and vertical angles of
30 degrees.

Using universal remote controls

When you want to program a universal remote control
to operate your HP MediaSmart LCD HDTV, if HP is not
listed in the supported brand codes, use a Philips TV
code. The HP remote control transmits Philips-licensed
remote control codes.
After programming your universal remote control with
a Philips TV code, it can operate your HP MediaSmart
LCD HDTV functions for volume, mute, power, and
input source.
Installing or replacing remote
control batteries
Insert two AAA non-rechargeable batteries into the
remote control, ensuring that you place them with the
proper polarity.
1
Press and open the cover on the back of the
remote control.
2
Insert the batteries into the remote control, and
make sure that you match polarities.
3
Close the cover.
30º
5m
Do not mix different types of batteries together (for
example, alkaline and carbon-zinc) or old batteries
with fresh ones.
Be sure to follow the correct polarity when installing
the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
When not using the remote for a long period of time,
remove the batteries to prevent damage or injury from
possible battery leakage.
Do not try to recharge batteries that are not intended to
be recharged; they can overheat and rupture. Follow
the battery manufacturer's directions for the batteries
you are using.
Always remove batteries as soon as they become
weak. Weak batteries can leak and severely damage
the unit. The battery life depends on how much the
remote control is used. Replace batteries when remote
control operation becomes erratic.
Do not take apart the batteries, heat them, or throw
them into a fire.
Using the Remote Control
29

Publicité

Table des Matières
loading

Table des Matières