Operation With 80 Programs; Use Of External Probe; Special Functions - Doyon WM45 Mode D'emploi

3.2.1 Initial recipes setting
Set the program number (ex.: P01, P02 etc.) appearing on the lower display (9) (PROGR. lights up) and
then the desired water quantity, appearing on the upper display (16). To store also the temperature, press
key and proceed as for manual operation. It is possible to exit from a recipe setting dosing the recipe
itself (press START), setting a new recipe (press P...). or automatically after 10 seconds: in all these
cases the recipe is stored.
Warning: recipe numbers from 1 to 9 must always be set using the format: 01, 02, etc...
3.2.2 With recipes already programmed:
To recall a recipe, enter the desired number (for example P28), which is shown for 3 seconds on the lower
display (9), while the upper displays show the relevant quantity and temperature.
Press START to carry out the dosing.
If modifications are required, set the new quantity and/or temperature as explained above.
To stop water delivery manually at any time press the STOP/C key. After that on the display (16) the
delivered water quantity flashes; to resume dosing press again the START key, otherwise, pressing the
STOP/C key, the quantity is cleared and it is possible to set a new quantity.
The equipment is fitted with an auxiliary precision electronic thermometer with a mobile probe (6), usable
at distances up to 5 metres.
Temperature readout on the display is continuous (9), except when the program number appears.

3.4 SPECIAL FUNCTIONS

•
With the double pressure of the P key, the device shows the succession of the recipes stored in
memory.
•
Holding the key for 10", the total amount of m³ delivered by the machine (with a decimal
number) is indicated: see example in Figure 9.

3.2 OPERATION WITH 80 PROGRAMS

3.3 USE OF EXTERNAL PROBE

2
t
M
5
4 5. 7
o t
E M
Figure -9