General Information - Doyon WM45 Mode D'emploi

THE MANUFACTURER DECLINES ALL RESPONSABILITY FOR ANY DAMAGE CAUSED
BY AN UNPROPER USE OF THE MACHINE AND/OR IN ENVIRONMENTAL CONDITIONS
OUT OF THE ALLOWED RANGE.
1) BEFORE BEGINNING THE USE OF THE MACHINE READ CAREFULLY THIS WHOLE
MANUAL.
THE OPERATION LISTED BELOW CANNOT BE PERFORMED BY
THE USER.
A LICENSED INSTALLER INTERVENTION IS NEEDED.
IN ALL THE CASES EVIDENCED WITH THIS SYMBOL IN THE TEXT
OF THIS MANUAL AN INTERVENTION OF A LICENSED INSTALLER IS
REQUIRED.
THE OPERATION EVIDENCED WITH THIS SYMBOL IS STRICTLY
FORBIDDEN.
5) IN CASE OF SUPPLY OF HOT WATER TO THE MACHINE, THE TEMPERATURE MUST
NOT BE HIGHER THAN 65°C (150°F).
6) THIS EQUIPMENT IS TO BEN INSTALLED WITH ADEQUATE BACKGLOW
PROTECTION TO COMPLY WITH FEDERAL, STATE OR LOCAL CODES HAVING
JURISDICTION.
This machine is a Doser-Mixer for the control of quantity and temperature of the water to be delivered
into the bread kneading machines, in small and larger industry.
The quantity control is carried out with an advanced microprocessor electronics, while temperature is
regulated by means of a thermostatic mixer and controlled with the same electronics.
It is a model suitable for the batch of large (up to 999,9 L or 999,9 Lb or 99 Lb and 15 oz) and small
quantities (under 5L or 10Lb).
STATEMENT
WARNING !
a) ELECTRICAL CONNECTIONS
b) HYDRAULIC CONNECTIONS
c) INSTALLATION
d) OPEN THE MACHINE
e) REPAIR WITH OR WITHOUT DISASSEMBLY
f) SET-UP AND ADJUSTEMENT PROCEDURES

1.0 GENERAL INFORMATION

1