Electrolux E24 WC 160 ES1 Notice D'instructions page 4

Installation
WARNING This product is intended for indoor use
only. Installation or use of this product
outdoors, or in any area exposed to the
elements , may cause serious injury,
product damage, or property damage.
Please read all instructions completely before attempt-
ing to install or operate the unit..
For best performance, air needs to circulate freely
over the cooling unit behind the wine cellar. The free-
standing design of the cellar means that it should
stand at least 1" (25 mm) from the rear and side walls.
Allow a clearance of at least 4" (100 mm) above the
wine cellar.
Adjust the feet of the wine cellar so that it is level from
back-to-front and side-to side. Use a leveling tool if
necessary. FIG.1
1. Remove the shipping pallet on which your wine
cellar rests.
2. IMPORTANT ! Adjust the feet to allow a 1 3/16"
(30mm) clearance under the wine cellar
3. Attach the distance bar using the two screws at the
top back on each side of the cellar. The rod ensures
the correct distance to the wall behind. FIG 2.
FIG 2
4
FIG. 1
Distance bar
Distance bar
Rear
4. For optimum performance, please place your wine
cellar far away from any source of heat
(radiator,range or intence sunlight) .
Please note that it must be possible to open the
wine cellar door at least 90° to allow the sliding
shelves to be pulled out.
5. Attach the driptray on the back as shown in
FIG 3a , 3b , 3c. . The screws are already attached
at the back.
FIG 3a
FIG 3c
1 3/16"
(30 mm)
Wall
1"
(25mm)
1"
(25mm)
Wall
FIG 3b