Ayce TGA2000i Mode D'emploi page 36

NOTE:
• The overload indicator (2) will be "ON" if the total AC load is over
generator Max. output of 2000 W.
• If the overload indicator (2) is "ON", disconnect the plug of the
electrical equipment; press the Reset button (7). No need to
restart the engine.
12V DC application
a) Set the breaker (8) to "ON"
b) Connect the DC cable to the DC output.
c) Clamp the red wire to the positive (+) terminal
and the black wire to the negative (-) terminal
of the equipment you would like to use.
d) If the DC overload protector activates, wait for a
few minutes and then press the DC breaker shown
on right.
USB application
The USB socket (11) should only be used for charging 5VDC Max.2.4A mobile or digital
equipment.
CAUTION!
• Be sure the total load is within generator rated output.
• Be sure the socket load current is within socket rated current.
CAUTION!
• Make sure that the appliance being connected is in good working
order, if it begins to act abnormally or stops suddenly,
disconnect it from the generator.
• Make sure the appliance does not exceed the maximum rated
load for the generator.
• Any device with contains an inductive load e.g. devices that
contain a motor may require more current on startup.
3. Shutting Down the Generator
a) Disconnect all appliances connected to the generator.
b) Set the engine switch to "OFF".
c) Set the vent valve knob to "OFF"
NOTE:
To stop the generator in an emergency simply set the engine switch to
"OFF".
NOTE:
The generator was shipped without oil. Before you start the engine, make
sure you add oil according to the instructions manual. If you start the engine without oil,
it will be damaged beyond repair and will not be covered under warranty.
MAINTENANCE
• Good maintenance is essential for safe, economical and trouble-free operation. It will
also help reduce air pollution.
• The purpose of the maintenance and adjustment schedule is to keep the machine in
the best operating condition.
• Turn off the engine before performing any maintenance. The exhaust contains
poisonous carbon monoxide gas. Please always select recommended accessories. The
accessories which have not equivalent quality may damage the machine.
• Please never use non-approved components and never remove the safety devices.
CAUTION!
• Always stop the engine before servicing, and disconnect all appliances to avoid
receiving an electrical shock.
• Periodic checks and maintenance are very important for keeping the generator in
good condition
09 10 | GB