Restoring Factory Settings; Maintenance And Cleaning - HomeMatic IP HmIP-FWI Notice D'installation Et Mode D'emploi

Restoring factory settings

7 Restoring factory settings
The device's factory settings can be restored. If you do this, you will
lose all your settings.
To restore the factory settings of the device, please proceed as follows:
• Press and hold down the system button (A) using a pen for 4 sec-
onds until the LED (A) quickly starts flashing orange (see figure 7).
• Release the system button.
• Press and hold down the system button again for 4 seconds, until
the LED lights up green (see figure 8).
• Release the system button again to conclude the procedure. The
device will perform a restart. After the restart, you can again inte-
grate your device into your Homematic IP system.
8

Maintenance and cleaning

The product does not require any maintenance. Enlist the help of an
expert to carry out any repairs.
Clean the device using a soft, lint-free cloth that is clean and dry. Do not
use any detergents containing solvents, as they could corrode the plastic
housing and label.
30