Installation; Pairing - HomeMatic IP HmIP-FWI Notice D'installation Et Mode D'emploi

Start-up
It is absolutely essential to ensure that all connecting cables are laid
so that they are physically separate from cables carrying mains volt-
age (e.g. in separate cable ducts or wiring conduits).
Permitted cable cross sections for connecting to the device are:
Rigid cable [mm
0.2 – 1.50
5.3

Installation

To install the device in a flush-mounting box, please proceed as follows:
• Switch off the power supply unit.
• Connect the device according to the connecting diagram in fig-
ure 2. You have the following connection options:
- Supply voltage (B)
- Open-drain output (C)
- Wiegand interface (D)
- Tamper contact (F)
- Doorbell button (G)
• Fix the actuator to an appropriate flush-mounting box (see figure
3).
• Supply the device with voltage (12 V) via the power supply unit to
activate the device's pairing mode (see figure 4) (see "5.3 Pairing"
on page 15).
5.4

Pairing

Please read this entire section before starting the pairing proce-
dure.
First set up your Homematic IP access point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system. For further information, please refer to the access point op-
erating manual.
26
] Flexible cable without ferrule [mm
2
0.2 – 1.50
]
2