Troubleshooting; Disposing Of The Device; Spare Parts List - Sabo MS-36 Mode D'emploi

12 TROUBLESHOOTING

PROBLEM POSSIBLE CAUSES
There is no electrical contact
between the machine and the
The machine does
battery.
not start when you
The battery is empty.
press the switch
The safety lock button (2) and the
trigger (1).
switch trigger (1) are not pressed
at the same time.
The grass deflector is not
mounted to the machine.
Heavy cutting line is used.
Grass winds around the motor
shaft and the trimmer head.
The machine
stops when you The motor is overloaded.
cut.
The battery or the machine is too
hot.
There is no electrical contact
between the machine and the
battery.
The battery is empty.
The line is stuck.
There is not enough line on the
spool.
The line does not
advance.
The line is worn and too short.
The line is wound around the
spool.
The line keeps
The machine is not used properly.
breaking.
Grass winds
around the shaft High grass is cut too close to the
housing and the ground.
trimmer head.
The line is not
The blade (7) is dull.
cutting well.
The vibrations are The line is worn down on one side
increasingly and did not advance when it was
significantly. supposed to.

13 DISPOSING OF THE DEVICE

Do not dispose of electric devices with household waste. Dispose of these devices at recycling centres. Contact the relevant authorities or your retailer for information about this.
Separate collection of used products and packaging allows materials to be recycled. The reuse of materials helps to prevent pollution and reduces the demand for raw materials.
Dispose of batteries at the end of their service life and in a manner that respects the environment. The battery contains material that is dangerous to you and to the environment.
Therefore, it must be disposed of separately in a facility that accepts lithium-ion batteries.

14 SPARE PARTS LIST

·
See spare parts catalogue
SOLUTION
·
Remove the battery.
· Check the contact.
·
Re-insert the battery.
Charge the battery.
·
Press the safety lock (2) on the battery and hold it down.
·
Push the switch trigger (1) to start the machine.
·
Remove the battery.
·
Attach the grass deflector to the machine.
Use only nylon cutting line with a diameter of 2 mm.
·
Stop the machine.
·
Remove the battery.
·
Carefully remove the grass from the motor shaft and/or the trimmer head.
·
Free the trimmer head from the grass. See the section "If grass wraps around the trimmer head or the shaft
housing" in these operating instructions.
·
You can continue using the motor when the load has been removed.
·
As you are cutting, move the trimmer head into and out of the grass you want to cut and do not cut more than 20 cm in
a pass.
·
Let the battery cool until its temperature is reduced.
·
Let the machine cool for approx. 10 minutes.
·
Remove the battery.
·
Check the contact.
· Re-insert the battery.
Charge the battery.
Oil with silicon spray.
Install a new spool. For this, see the section in these instructions about replacing the line.
·
Remove the battery.
· Pull the line while pushing the trimmer head.
Remove the line from the spool and wind it up. For this, see the section in these instructions about replacing the line.
·
Cut with the tip of the line and avoid contact with rocks, walls and other hard objects.
·
Advance the cutting line regularly for full cutting breadth.
·
Cut high grass from top to bottom.
·
Do not cut more than 20 cm in each pass to prevent grass wrapping around.
·
Sharpen the blade with a file or replace it.
Make sure that the line can move freely on both sides. Move the line to check.
38