Sabo MS-36 Mode D'emploi page 36

WARNING
Never allow brake fluids, petrol products based on oils, etc. come into contact with plastic parts. Chemicals can damage, weaken or destroy plastic, which can lead to serious injuries.
CLEAN MACHINE
·
Clean the machine after use with a damp towel that is moistened with neutral cleaning agent.
·
Do not use aggressive cleaning agents or solvents to clean the plastic parts or handle.
·
Keep the trimmer head free of grass, leaves or excess grease.
·
Keep the air openings clean and free of dirt to prevent overheating and damage to the motor or to the battery.
·
Do not spray water on the motor or the electrical components.
Only the parts listed in the spare parts list are authorised for repair or replacement by the customer. All other parts have to be replaced by the authorised customer service.
REPLACING THE SPOOL
see figure 11 to 15
·
Remove the battery.
·
Press both trimmer head tabs (19) on the side of the trimmer head cover (17) while you remove them.
·
Remove the old spool (18).
·
When inserting the new spool, make sure that the line is in the slot for the new spool. Make sure that the end of the line is coming about 15 cm out the slot.
·
Insert the new spool so that the line and the slot are aligned with the line exit hole (20). Guide the line through the line exit hole.
·
Reattach the trimmer head cover (17) by pushing the tabs into the slots until they lock into place.
REPLACING THE LINE
See figure 12 and 16 to 18
·
Remove the spool (18) from the trimmer head.
NOTE
Remove any old line that may still be on the spool.
NOTE
Use only nylon cutting line with a diameter of 2.0 mm.
IMPORTANT
You must mount the cut-off blade (7) if you are using the trimmer head (8).
·
Cut a line with an approximate length of 3 m.
·
Bend the line in the middle and hold the loop in the slot on the middle rib of the spool.
·
Wrap the lines with your finger evenly and firmly between the lines in the specified direction around the spool. Do not wind the cutting line beyond the outer ribs of the spool.
·
Place the line into the guide grooves.
ASSEMBLING THE TRIMMER HEAD
See figure 19
·
Place the positioning tool (21) in the positioning hole (26) and push the spacer (28) onto the shaft so that the positioning tool engages in one of the grooves of the spacer.
·
Slide the trimmer head (8) onto the shaft and turn the trimmer head until the positioning tool stops the rotation.
·
Turn the trimmer head counter-clockwise to tighten.
·
Remove the positioning tool from the hole.
DISASSEMBLING THE TRIMMER HEAD
See figure 19
·
Press the positioning tool (21) into the positioning hole (26) and turn the trimmer head (8) until the positioning tool stops the rotation.
·
Turn the trimmer head clockwise to unscrew.
·
Remove the positioning tool from the positioning hole.
ASSEMBLING THE CUT-OFF BLADE
See figure 19 and 20
WARNING
Wear gloves and exercise caution with sharp edges.
36