Commisioning - Sabo MS-36 Mode D'emploi

WARNING
Never use blades, hammering devices, wires or ropes on this product. Do not use attachments or accessories that are not recommended by the manufacturer of this device. Using
attachments or accessories that are not recommended can lead to serious injuries.
ASSEMBLING THE SHAFT
See figure 3
·
Loosen the bottom screw on the coupler with the Allen wrench (13).
·
Press the release button (11) on the lower shaft (5).
·
Press and hold the release button (11) while pushing the lower shaft (5) into the coupler.
·
Rotate the lower shaft (5) until the release button (11) engages in the positioning hole (12).
·
Manually tighten the bottom screw on the coupler with the Allen wrench (13).
ATTACHING THE AUXILIARY HANDLE
See figure 1 and 4
CAUTION
Be aware of the cable when assembling the auxiliary handle. Be careful not to pull on it or crush it. Damage to the cable can cause unexpected malfunctions.
·
Loosen the connecting screw (14).
·
Remove the upper support (15) and the lower support (16).
Note: Do not forget the spring between the upper (15) and lower support (16).
· Place the auxiliary handle (4) between the upper and lower support.
·
Place the auxiliary handle with the supports on the housing of the shaft.
·
Place the auxiliary handle somewhere that is comfortable for you.
·
Lock the auxiliary handle with a connecting screw (14).

9 COMMISIONING

·
Put the harness over your shoulder so that the latch is in the front and the eye bolt is positioned on the right side.
·
Close the latch.
·
Now you can hook the shoulder harness into the hanging loop (29).
·
Hold the brushcutter in your right hand by the right handle and hold the left handle in your left hand.
·
Hold the device tight during use.
·
The brushcutter should be held in a comfortable position.
INSERTING THE BATTERY
WARNING
·
Replace a damaged battery or charger.
·
Stop the machine and wait for the motor to come to a stop before removing the battery.
·
Read, understand and follow the procedures in the operating instructions for the battery and the charger.
See figure 5
· Insert the battery in the brushcutter. Align the bar on the battery with the guide in the battery shaft.
·
Allow the latch on the bottom of the battery to lock in place and make sure the battery is securely inserted before beginning use.
REMOVING THE BATTERY
See figure 5 and 6
·
Release the switch trigger (1) to stop the brushcutter.
·
Press and hold the battery latch button on the bottom of the battery while you remove the battery from the battery shaft.
STARTING/STOPPING THE BRUSHCUTTER
See figure 6
·
To stop the brushcutter, press and hold the safety lock (2) and also press the switch trigger (1).
·
To continue using the brushcutter, release the safety lock (2) and continue holding the switch trigger (1).
·
To stop the brushcutter, release the switch trigger (1).
WARNING
Noise: A certain amount of noise from the machine is unavoidable. High noise levels during work is only allowed during certain times. Observe the quite periods and limit working time to a
minimum. Persons who are not working with the device or who are remaining nearby must wear ear protection.
Vibration: Always wear safety and anti-vibration gloves. Excessive vibrations can cause Raynaud's syndrome or carpel tunnel syndrome. If you experience an unpleasant feeling while
using the machine or if the skin on your hands becomes discoloured, stop working. Schedule reasonable rest periods. Frequent and regular users should carefully check the conditions of
their hands and fingers.
34