Vox Adio Air BS Manuel D'utilisation page 16

Effect types
Effects 1 types (FX1 knob):
This models a compressor pedal that is popular for its percussive clean sound. It can also
COMP
produce a singing, mellow, sustain. Adjusts the sensitivity with the knob.
This models an auto-wah; a device that creates an automatic "wah" effect that varies with your
picking dynamics (i.e., how hard or soft you hit the strings) - a quirky, but useful effect. Adjusts
T.WAH
the sensitivity of response to the input volume with the knob.
This models a bass fuzz pedal. Adjust the gain with the knob.
FUZZ
This models a stereo chorus, which creates a rich and spacious sound. Adjust the modulation
CHORUS
speed with the knob.
Effects 2 types (FX2 knob) : delay/reverb types
This models an analog delay that uses a Bucket Brigade Device (BBD). Its audio quality is lo-fi,
A.DLY
but it is popular for its warm sound. Adjust the mix amount of the delay sound with the knob.
(ANALOG DELAY)
Set the delay time with the TAP button. The maximum delay time is approximately 1 seconds.
This is a stereo delay effect that has slightly staggered notes from the right and left speakers. The
WIDE DLY
operation of the knob and button and the maximum delay time are the same as with A.DLY.
(WIDE DELAY)
This simulates the spring reverb that's built into many guitar amps. Adjust the mix amount of
SPRING
the reverb sound with the knob. Set the reverb time with the TAP button.
This models the reverberation of a concert hall containing numerous echo components. The
HALL
operation of the knob and button is the same as with SPRING.
Noise reduction
This applies a noise-reducing effect.
As with amps and effects, noise reduction must be set for
each program. If, while changing settings in the user
program mode, you switch to another program or to
manual mode or turn off the amp before saving the
settings, the changes that you made will be lost.
1.
Hold down the WIDE button for about 1 second. The
WIDE LED blinks, and the USER PROGRAMS LEDs
indicate the noise reduction setting (the BANK LED
lights up in orange).
2.
Press the BANK/MANUAL button or a USER PRO-
GRAMS button to change the level of the noise reduc-
tion.
LEDs Button
BANK/MANUAL
3.
Press the WIDE button. The BANK and USER PRO-
GRAMS LEDs return to their previous indications.
Setting
OFF
1 Low
2 |
3 |
4 High
Audio equalizer
This adjusts the tone of the audio input from the
AUX IN jack or via a Bluetooth connection.
1.
Hold down the WIDE button for about 2
seconds. The WIDE LED blinks slowly, and the
USER PROGRAMS LEDs indicate the current
equalizer setting (the BANK LED lights up in
orange).
2.
Press the BANK/MANUAL button or a USER
PROGRAMS button to change the equalizer
setting.
LEDs
BANK/MANUAL OFF
3.
Press the WIDE button. The BANK and USER
PROGRAMS LEDs return to their previous
indications.
Tip Using Tone Room, you can change the settings
specified for 1 through 4.
16
Button Setting
1 LOUD
2 BASS BOOST
3 MID BOOST
4 TREBLE BOOST