Harman Infinity Reference 3004A Mode D'emploi page 4

WIRING FOR POWER AND GROUND
At amplifier:
+12V
Fuse holder, fuse
18'' (46cm)
Battery
EN
aftermarket stereo REM out
(used only with low-level signal inputs)
At ground location:
Factory Bolt
Note: Remove any paint
below ring connector
WIRING FOR INPUT SIGNAL
Reference 3004A low-level signals
FRONT REAR PRE OUT
DC
TURN-ON
L
MODE
REM
R
From stereo front
low-level outputs
From stereo rear
low-level outputs
Note: when using low-level signals and remote turn-on lead, set
the " " switch to "
switch to " ".
Reference 7005A low-level signals
DC
HI2
TURN-ON
INPUT
HI1
MODE
LEVEL
REM
LO
EXT
L
INPUT
INT
R
From stereo front
low-level outputs
From stereo rear
low-level outputs
REM GND
Chassis ground (–)
Remote turn-on to
Ring Connector
Ground Wire
Star Washer
INPUT
LEVEL
To optional
second amplifier
low-level inputs
" and the "
FRONT REAR SUB
From stereo subwoofer
low-level outputs
Note: when using low-level signals and remote turn-on lead with
the Reference 7005A, set the "
"
and the SUB "
switch to " ".
Reference 3004A high-level signals
Loosen
Screws
DC
TURN-ON
MODE
REM
Stereo front
speaker wires
Note: when using high-level signals, set the "
switch to " " and the "
sound plays, change the "
Reference 7005A high-level input signals
HI2
HI1
LO
"
Note: when using high-level signals with the Reference 7005A, set
the "
to " ", and the "
plays, change the "
" switch to "
" switch to " " and the "
Insert
Wires
FRONT REAR PRE OUT
INPUT
L
LEVEL
R
To optional
second amplifier
low-level inputs
Stereo rear
speaker wires
" switch to "HI1". If no
" switch to "
FRONT REAR
L
R
Stereo front
speaker wires
Stereo rear
speaker wires
" switch to " ", the SUB "
" switch to " ". If no sound
" switch to " ".
"
Tignten
Screws
HI2
HI1
LO
"
".
SUB
" switch