Toshiba VN-M150HE Manuel Du Propriétaire page 10

22
15 17
11
Remote controller sensor indicator (*1)
Displayed when the remote controller sensor is
used.
12
Pre-heat indicator (*1)
Displayed when the heating mode is energized or
defrost cycle is initiated.
While this indication is displayed, the indoor fan
stops or operate in fan mode.
13
No function indicator
Displayed when the function requested is not
available on that model.
14
Fan speed indicator (*1)
Indicates the selected fan speed:
(Auto)
(High)
(Medium)
(Low)
15
Louver Number display. (*1)
(exapmle:01, 02, 03, 04)
16
Power saving mode display (*1)
Displayed during capacity saving mode.
17
Louver lock indicator (*1)
Displayed when a louver is locked. (4-way
cassette type only)
18
UNIT No. indicator
The number of the Air to Air Heat Exchanger
selected using the UNIT button or that of the unit
in which an error has occurred.
19
Central control indicator
Displayed when a central control device such as a
central controller is also used. If the central control
17-EN
18
19 16
20
11
12
14
13
device prohibits the use of local remote
controllers, blinks when any of the
or TEMP. buttons are pressed and the
operation is rejected.
The items controllable with the remote differ
depending on the mode of central control. Refer to
the owner's manual of the central control device
you are using for more information
20
Operation mode controlled indicator (*1)
Displayed when MODE button is pushed while
operation mode is fixed to cool or heat by the air
conditioner administrator.
– 9 –
24
26
27
21
Operation ready display (*1)
This display appears on some models.
22
,
Service display
Displayed while the protective device works or a
trouble occurs.
23
Ventilation fan speed indicator
Indicates the ventilation fan's speed.
, or is indicated.
When the remote is used to control air
conditioners together with the Air to Air Heat
Exchanger as a group, VENT FAN indicator
appears (blinks) only when the
pressed.
(High)
(Low)
(SA > EA)
(SA < EA)
24
Ventilation mode indicator
Indicates the selected ventilation mode.
or is indicated.
(Automatic mode)
(Heat exchange
mode)
(Bypass mode)
25
24-hour ventilation indicator
Displayed during 24-hour ventilation.
* Displayed when the setting is activated.
26
Nighttime heat purge indicator
Displayed during the nighttime heat purge
operation.
* Displayed when the setting is activated.
22 28
25 23
27
Ventilation on-standby indicator
Displayed while the Air to Air Heat Exchanger is on
standby. While this indicator is displayed, the Air to
Air Heat Exchanger is not in operation.
* Displayed when the setting is activated.
28
Ventilation indicator
If the remote is used to control the Air to Air Heat
,
Exchanger in the Air to Air Heat Exchanger system
linked with air conditioners, and separate
operation of the unit is set to available, the
indicator is displayed while the unit is running.
* The indicator is not displayed when the unit is
button is
running in a system equipped with only the Air to
Air Heat Exchanger.
(*1):
Not displayed. These functions are not available for Air
to Air Heat Exchanger.
* Displayed when the
setting is activated.
,
21
18-EN