If You Have A Question; Displayed Information (For Troubleshooting) - Fujitsu Ten ECLIPSE CD1000 Manuel D'utilisation

If you have a question:

Displayed information (for troubleshooting)

The information listed in the chart below is displayed to show the status of the CD, Refer to the chart for
the appropriate action.
Symptoms
Sound cannot be heard
from the speakers.
This receiver does not
work at all.
ASM automatic presetting
does not work.
Static noise while listening
to the radio.
Disc is automatically
ejected.
·CD-R/CD-RW cannot be
played back.
·Tracks on the D-R/CD-
RW cannot be skipped.
Disc can be neither played
back nor ejected.
Disc sound is sometimes
interrupted.
"NO DISC"appears on the
display.
Causes
The volume level is set to the minimum
level.
Connections are incorrect.
The built-in microcomputer may have
functioned incorrectly due to noise, etc.
Signals are too weak.
The antenna is not connected firmly.
Disc is inserted upside down.
CD-R/CD-RW is not finalized.
Disc is locked.
The CD player may have functioned
incorrectly.
You are driving on rough roads.
Disc is scratched.
Connections are incorrect.
Disc is inserted incorrectly.

If you have a question:

Remedies
Adjust it to listening level.
Check wiring and
connections.
Reset the receiver .
Store stations manually.
Connect the antenna firmly.
Insert the disc correctly.
·Insert a finalized CD-R/
CD-RW.
·Finalize the CD-R/CD-RW
with the component which
you need for recording.
Unlock the disc (see page
16).
Eject the disc forcibly (see
page 16).
Stop playback while driving
on rough roads.
Change the disc.
Check wiring and
connections.
Insert the disc correctly.
IX
X
25