Application; Assembly - Haussmann 59595059 Guide De L'utilisateur

cord or plugs immediately. Incorrect reassembly or
damage may result in electric shock or fire.
3. To ensure the longest battery life and best battery
performance, always charge the battery when the
air temperature is between 18-24
not charge the battery pack when the temperature is
below 4 0 C (40 0 F), or above 40
important. Failure to observe this safety rule could
cause serious damage to the battery pack.
4. Do not recharge battery in a damp or wet
environment. Do not expose charger to rain or
snow. If battery case is cracked or otherwise
damaged, do not insert into charger. Battery short
or fire may result.
5. Battery leakage may occur under extreme usage
or temperature conditions. Avoid contact with
skin and eyes. The battery liquid is caustic and could
cause chemical burns to tissues. If liquid comes in
contact with skin, wash quickly with soap and water,
then with lemon juice or vinegar. If the liquid contacts
your eyes, flush them with water for a minimum of 10
minutes and seek medical attention.
6. Place charger on flat non-flammable surfaces and
away from flammable materials when re-charging
battery pack. The charger and battery pack heat
during charging. Carpeting and other, heat insulating
surfaces block proper air circulation, which may cause
overheating of the charger and battery pack. If smoke
or melting of the case are observed unplug the charger
immediately and do not use the battery pack or charger.
7. Use of not recommended attachments and accessories
may result in a risk of fire, electric shock or injury to
persons.
8. When batteries are not in tool or charger, keep
them away from metal objects. For example, to
protect terminals from shorting DO NOT place
batteries in a tool box or pocket with nails, screws,
keys, etc. Fire or injury may result.
9. DO NOT PUT BATTERIES INTO FIRE OR EXPOSE
TO HIGH HEAT. They may explode.

APPLICATION

Intended Use
This tool is intended for cutting wood and plastic.
Check the delivery parts
Carefully remove the tool from its packaging and check
as the following parts are complete:
--Cordless circular saw
0 C (65-75 0 F). Do
0 C (104 0 C). This is
20
--1 PC hex key
If any parts are missing or damaged, please contact the
Customer service at 1-866-206-0888.
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page
1. Battery pack
2. Handle grip
3. Depth adjustment locking knob
4. Lock off button
5. Motor housing
6. Auxiliary handle
7. Fence locking knob
8. Bevel angle locking knob
9. Spindle lock
10. Upper blade guard
11. Trigger switch
12. Base plate
13. Bevel scale
14. Lower blade guard lever
15. Lower rotating blade guard
16. Hex key

ASSEMBLY

ATTACHING THE BLADE

!
WARNING
Disconnect battery pack from tool and place the
switch in the locked or off position before making any
assembly, adjustments or changing accessories.
Such preventive safety measures reduce the risk of
starting the tool accidentally.
1. Turn blade stud with wrench provided clockwise
and remove blade stud and ourer washer
(Fig. 2). If the shaft moves while attempting to loosen
the blade stud press the spindle lock button.(9)
2. Retract the lower guard all the way up into the upper
guard. While retracting the lower guard, check
operation and condition of the lower guard spring
3. Make sure the saw teeth and arrow on the blade
point in the same direction as the arrow on the lower
guard.
4. Slide blade through slot in the foot and mount it
against the inner washer on the shaft. Be sure
the large diameter of the outer washer lays flush
against the blade.