Samsung NY36R9966P Serie Manuel D'installation page 28

Installation instructions
Step 10. Plug in and place
WARNING
• BEFORE OPERATING OR TESTING, follow the grounding requirements on pages
17–18 in this manual. Improper connection of the grounding plug can result in
a risk of electric shock.
Please review "Electrical requirements" on pages 17–18.
• Altering any part of this system may result in a short or overload.
1. Plug in the power cord. Make sure the outlet meets local or national electrical
codes as referenced on pages 17–18.
2. Slide the range into place.
3. Check the gas supply line to make sure it did not get damaged and it stayed
connected during positioning.
4. Check to make sure the back leg of the range has slid into the anti-tip bracket.
Carefully tip the range forward
back brace and prevents tip-over.
NOTE
If the power cord is plugged in improperly, the following message appears on the
display.
• LCD, PMOLED : Wire installation fail
• LED : bAd LinE
Reconnect the power cord properly, and the message disappears.
28 English
Install_NY9900R_CHEF_NY36R9966PS_AA_DG68-01106B-01_EN+MES+CFR.indb 28
to ensure that the anti-tip bracket engages the
Step 11. Moving and placing the range
1.
2.
Air Sled Insert
NOTE
Adjust the leveling legs only as far as necessary to level the range. Extending the
leveling legs more than necessary or removing legs can cause the range to be
unstable.
3.
4.
5.
6.
Due to the weight, heavy equipment
movers such as Air Sled should be used
to move this unit. The weight must be
supported uniformly across the bottom.
After transporting the range by Air
Sled where you want, the range can
be leveled by adjusting the legs with
a wrench while Air Sled is supported.
Using a wrench, level the range by
turning the front leveling legs in or
out as necessary. Counterclockwise
shortens the leg and lowers the range.
Clockwise lengthens the leg and raises
the range.
If range is next to or between cabinets,
make sure the cooktop (without the
surface burner grates) is level with the
countertops.
Position an oven rack in the center rack
position.
Check the level of the range with a
carpenter level using the two positions
shown at right.
After the range becomes level, Use Air
Sled to move the range away from the
wall so that the anti-tip bracket can be
installed.
2019-03-14 3:56:01