Installation Requirements; Location Requirements - Samsung NY36R9966P Serie Manuel D'installation

Installation requirements

Location requirements

Clearances and dimensions
NOTE
• For OTR over Gas Stove, please follow local GAS CODE.
• BEFORE YOU BEGIN to install this appliance, refer to the following information,
dimensions, and clearances. Do not locate the range where it may be subject
to strong drafts. Provide adequate clearances between the range and adjacent
combustible surfaces. These dimensions must be met for safe use of the range.
The location of the electrical outlet and gas piping may be adjusted to meet
the following dimensions and clearances.
• For installation in Canada, a free-standing range is not to be installed closer
than 4.7 in (12 cm) from any adjacent surface.
CAUTION
This range has been designed to comply with the maximum allowable wood
cabinet temperature of 194 °F (90 °C). Make sure the wall covering, countertops,
and cabinets around the range can withstand the heat (up to 194 °F [90 °C])
generated by the range. If not, discoloration, delamination, or melting may occur.
Install_NY9900R_CHEF_NY36R9966PS_AA_DG68-01106B-01_EN+MES+CFR.indb 13
36 in
(914 mm)
6 in*
6 in*
(15.2 cm)
(15.2 cm)
24 in
(61 cm) Lower
37 ½ in
Cabinet Depth
(953 mm)
* Side clearance above cooking surface to any objects, i.e., wall.
13 in (33 cm)
30 in (76.2 cm)
Overhead
Cabinet Depth
30 in (76.2 cm)
18 in
(45.7 cm)
0 in (0 cm)
22.6 in
Clearance Below
(573.5 mm)
Cooking Top
and at Rear and
0 in (0 cm)
Sides of Range
English 13
2019-03-14 3:55:52