Zephyr ALU-E43BSX Guide D'utilisation, D'entretien Et D'installation page 14

CONTROLS
7
Clean Filters Indicator
Mesh Filter Clean Reminder (always enabled)
- After 120 hours of fan usage, the clean fitlers indicator will turn on and the two side LED light strips
will flash on and off indicating it is time to clean the mesh filters.
- To Reset with Hood Controls: With hood off: hold the
indicator will turn off confirming the 120 hour timer has been reset.
- To Reset with Remote Controls: With hood off: hold the Blower On/Speed Selection button and Lights
button simultaneously.
Charcoal Filter Replace Reminder (disabled by default, must be enabled if recirculating hood)
- To Enable Charcoal Filter Replace Indicator:
With hood off: press and hold the
indicators will illuminate for three seconds confirming function enabled.
- To Disable Charcoal Filter Replace Indicator:
With hood off: press and hold the
indicators will blink two times confirming function disabled.
- After 240 hours of fan usage, the clean fitlers indicator will turn on and all LED light strips will flash on and
off indicating it is time to replace the charcoal filters.
- To Reset with Hood Controls: With hood off: hold the
will turn off confirming the 240 hour timer has been reset.
- To Reset with Remote Controls: With hood off: press and hold the Delay Off button and the Lights button
simultaneously.
8 Lights Indicator
- When lights are on high, medium or low, lights indicator will illuminate.
9
Clean Air On / Off
- Clean Air is a feature that turns the fan on every 4 hours for 10 minutes to remove stagnant air in the kitchen.
The Clean Air feature is disabled by default and must be enabled by the user.
- To enable Clean Air Function: With hood off, hold the
seconds. The LED indicators "Q, 1, 2, 3" will illuminate for 3 seconds and the fan will turn on speed 1 for
10 minutes. After 10 minutes, the fan will turn off and the 4 hour timer will begin.
- To disable Clean Air Function: With hood off, hold the
The LED indicator "Q" will illuminate for 3 seconds indicating the function has been disabled.
button for three seconds. The clean filters
button and button simultaneously for three seconds. All LED
button and button simultaneously for three seconds. All LED
button for three seconds. The clean filters indicator
button and
and
- 14 -
button simultaneously for three
button simultaneously for three seconds.