Installing The Appliance - Atag KD8178AFUU/A01 Instructions De Montage

4.1 Installing the appliance

u Detach the connecting cable from the rear of the appli-
ance. Remove the cable holder otherwise there will be
vibratory noise.
u Lay the connecting cable with
the help of string in such a way
that the appliance can be
easily connected following
installation.
u Slide the appliance 3/4 of the way into the recess.
Fig. 7 (4,6,7) .
u Remove the covers
u Fit the equaliser trim
Fig. 9 (11) concentrically
onto the appliance: Slide
it into the recess and
engage it in the
keyholes.
u Screw all the mounting
Fig. 10 (12) to
brackets
the pre-drilled holes in
the appliance door
using hexagon screws
Fig. 10 (13) .
For 16 mm-thick unit
walls:
Fig. 11 (14) and
u Clip spacer
Fig. 7 (15) onto the
spacer
hinges.
u Attach the top
Fig. 12 (16) and the bottom
cover Fig. 12 (17) to the
mounting brackets.
u Fasten the top mounting
Fig. 12 (17) with
bracket
screws Fig. 12 (19) and
the bottom one
Fig. 7 (19) so that
screws
the brackets can still be
moved a little to the left
and right.
u Strip the protective film off the cover trim
Fig. 13 (20) .
u Apply the cover trim
projection of the cover
handle side, flush with the front, and adhe-
sively affix it to the side wall of the appli-
ance.
u If necessary, shorten the cover strip
Fig. 13 (20) at the bottom: The cover strip
Fig. 13 (20) has to end 3 mm above the
upper edge of the lower mounting bracket
Fig. 7 (17) .
Slide in and align the appliance:
u Slide in the appliance until the covers
Fig. 12 against the side wall of the kitchen unit.
For 16 mm-thick unit walls:
Fig. 7
u Allow the spacers to abut
against the side wall of the
kitchen unit.
For 19 mm-thick unit walls:
u Align the front edges of the
hinges so as to be flush with
the side wall of the kitchen
unit.
Fig. 8
For kitchen units (16 mm and 19 mm) with door stop
components (knobs, sealing lips etc.):
u Allow for the extra distance (depth of the door stop compo-
nents): Allow hinges and covers
the extra distance.
All appliances:
Fig. 9
u Vertically align the appliance by means of the height-adjust-
able feet, using the accompanying open-ended spanner
Fig. 7 (21) .
w The appliance is now correctly positioned in depth. The
distance from the front edge of the side wall of the unit to the
appliance body is 42 mm all the way round (allow for door
stop components, such as knobs and sealing lips.)
Note
Incorrect installation will lead to malfunction!
If the distance is not kept, the door may not close. This may
Fig. 10
lead to icing, to condensate forming and to malfunction.
u Be sure to keep to the clearance of 42 mm all the way
round. (Allow for door stop components, such as knobs and
sealing lips.)
Tightly screw the appliance into place in the recess:
Fig. 11
Installation
cover
with
Fig. 13 (20) to the
Fig. 12 (16) on the
Fig. 12 (16) abut
Fig. 12 (16) to protrude by
Fig. 12
Fig. 13
Fig. 14
Fig. 15
17