Techno Line WS-9632-IT Livret D'instructions page 42

the LCD will light up briefly. Following the time as 0:00 and the "Weather man" icon will be
displayed. If these are not displayed after 60 seconds, remove the batteries and wait for at least
10 seconds before reinserting them.
3. After inserting the batteries, the Weather station will start receiving data from the transmitter. The
outdoor temperature and the signal reception icon should then be displayed on the Weather
station. If this does not happen after 3 minutes, the batteries will need to be removed from both
units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, this should under good conditions be
a distance no more than 100 meters between the final position of the Weather Station and the
transmitter (see notes on "Mounting" and "868 MHz Reception").
5. Once the remote temperature has been received and displayed on the Weather station, the DCF
time (radio controlled time) code reception is automatically started. This takes typically between
3-5 minutes in good conditions.
Note:
Daily DCF reception is done at 02:00 and 03:00 every day. If the reception at 03:00 is not successful, then
at 04:00 and 05:00 and 06:00 there are other tries, until one is successful. If the reception at 06:00 is still
not successful, then the next try takes place at 02:00 next day.
41