Operating The Dryer - LG DLE5001W Mode D'emploi

OPERATING THE DRYER

26
CLEAN THE LINT FILTER
1
If the lint filter has not already been cleaned, lift out
the filter and remove the lint from the last load. This
will help ensure the fastest and most efficient drying
performance.
2 LOAD THE DRYER
Load the dryer with the wet laundry from the washer.
If the load is extra large, you may need to divide it into
smaller loads for proper performance and fabric care.
3 TURN ON THE DRYER
Press the POWER button to turn on the dryer. The cycle
LEDs will illuminate and a beep will sound, if turned on.
Refer to page 25.
SELECT A CYCLE
4
Turn the Cycle Selector Knob either direction until the
LED for the desired cycle is on. The preset temperature,
dry level, and option settings for that cycle will be
shown. Refer to page 27.
SELECT CYCLE mODIFIERS
5
Default settings for the selected cycle can now be
changed if desired. This can be done using the cycle
modifier buttons as shown on page 30 (temperature, dry
level, and beeper).
NOTE: Not all options or modifiers are available on all
cycles. A different beep will sound and the LED will not
come on if the selection is not allowed.
SELECT CYCLE OPTIONS
6
Cycle options can be added using the option buttons as
shown on pages 31-32 (Wrinkle Care, Damp Dry Beep,
Rack Dry and Child Lock).
NOTE: Not all options or modifiers are available on all
cycles. A different beep will sound and the LED.
BEGIN CYCLE
7
Press the START/PAUSE button to begin the cycle. The
cycle can be paused at any time either by opening the
door or by pressing the START/PAUSE button. If the
cycle is not restarted within 4 minutes, the dryer will
shut off and the cycle settings will be lost.
END OF CYCLE
8
When the cycle is finished, the chime will sound if it is
set. Remove your clothing from the dryer immediately to
reduce wrinkling. If Wrinkle Care is selected, the dryer
will tumble briefly every few minutes to help prevent
wrinkles from setting in the clothes.