Stihl SR 430 Notice D'emploi page 6

English
In an emergency, follow the chemical
manufacturer's instructions provided or
on the label.
Mixing the spray solution
Mix the plant protection product strictly
in accordance with the manufacturer's
instructions – incorrect mixtures may
produce toxic fumes or explosive
solutions.
– Never spray liquid plant control
chemicals undiluted.
– Prepare solution and fill the
container outdoors only or in well-
ventilated locations.
– Only prepare sufficient solution for
the job in hand so that nothing is left
over.
– Mix different chemicals only in
accordance with the manufacturer's
instructions – incorrect mixtures
may produce toxic fumes or
explosive solutions.
– Do not mix different plant protection
products unless such a mixture is
approved by the manufacturer.
Filling the Container
– Stand the power tool on a level
surface – do not fill the container
above the maximum mark.
– To reduce the risk of injury, do not
fill the unit while wearing it on your
back.
– Close the valve lever before filling.
4
– When filling from central water
supply, do not immerse the end of
the hose in the solution – sudden
low pressure in the system may
cause the solution to be sucked
back into the water supply.
– Before filling the container with
spray solution, carry out test run
with fresh water and check all parts
of the sprayer for leaks.
– After filling, fit the filler cap and
tighten it down firmly.
Using the unit
– Work only in the open or in very well
ventilated locations, e.g. open
greenhouses.
– Do not eat, drink or smoke while
working with plant control
chemicals.
– Never blow through nozzles or other
components by mouth.
– Avoid contact with plant control
chemicals – immediately change
clothing contaminated with plant
control chemical.
– Do not spray in windy conditions.
Unfavorable weather conditions may
result in an incorrect concentration of the
plant protection product. Overdosing
may damage plants and the
environment. Under-dosing may result
in unsuccessful plant treatment.
In order to reduce the risk of damage to
the environment and plants, do not
operate the sprayer if:
– in windy conditions
– at temperatures above 25°C in the
shade
– in direct sunlight
In order to reduce the risk of accidents
and damage to the power tool, never
operate the power tool with:
– flammable liquids
– viscous or sticky liquids
– caustic or corrosive chemicals
– liquids hotter than 50°C
Storage
– During work breaks, do not leave
the power tool in the hot sun or near
any heat source.
– Do not store spray solution in the
container for longer than one day.
– Store and transport spray solution
only in approved containers.
– Never store the spray solution in
containers intended for foods,
drinks or animal feed.
– Do not store spray solution with
foods, drinks or animal feed.
– Keep spray solution out of the reach
of children and animals.
– Store the unit empty and clean.
– Store the spray solution and unit in
a place secured against
unauthorized use.
– Store the spray solution and unit in
a dry place protected from frost.
SR 430, SR 450