Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The detergent flow does not
stop
The suction motor does not
start
The squeegee does not clean
or suction is ineffective
The machine does not move
The machine tends to pull to
one side
ENGLISH
24
• the detergent tank is empty
•
the
hose
delivering
detergent
to
the
blocked
• the tap is dirty or faulty
• the tap stays open, because it is
damaged or very dirty
• the suction switch is in the '0'
position (off)
• there is no power to the suction
motor or the motor is faulty
• [B] [BT]= the fuse has blown
• the edge of the rubber blades in
contact with the floor is worn
• the squeegee or hose is
blocked or damaged
• the float switch has tripped (dirty
water drum), is clogged by dirt or
broken
• the suction hose is blocked
•
the
suction
hose
connected to the squeegee or is
damaged
• there is no power to the suction
motor or the motor is faulty
• there is no power to the
brush/drive motor or it is faulty
• the reduction unit is broken
(therefore the brush does not
turn)
• the brush motor thermal cutout
has
tripped;
the
motor
overheated
• [B] [BT]=
the batteries are flat
and the brushes have shut down
• the direction adjustment knob
must be adjusted appropriately
for the floor
• fill it
the
• unblock and open the circuit
brush
is
• clean or replace the tap by
unscrewing the screw (ref.
1 fig. 11)
• have the tap cleaned or
replaced
• turn the suction switch on
• check that the motor power
connector
connected
wiring; in the second case
have the motor replaced
• [B] [BT]= replace the fuse
• replace the rubber blade
• unblock and repair the
damage
• empty the dirty water drum
or reset the float switch
• unblock the hose
is
not
• connect or repair the hose
• check that the motor power
connector
connected to the main wiring
and that the fuse is not
blown; in the second case
have the motor replaced
• in the first case, place the
brush
position
brush/drive
second case, check that the
brush/drive motor is correctly
connected to the main wiring;
in the third case replace the
motor
CT90, drive motor electronic
board protection activated,
check the type of alarm
present on the board (see
chapter 11)
• have the reduction unit
replaced
• stop the machine, turn it off
is
and leave it to cool for at
least 45'
• [B] [BT]= recharge the
batteries
• regulate the direction of
movement by adjusting the
speed adjustment knob
is
correctly
to
the
main
is
correctly
switch
in
the
"1"
and
press
the
lever;
in
the
Publicité
Chapitres
Table des Matières
