Handling And Installation; Lifting And Transporting The Packaged Machine; Checks On Delivery; Unpacking - IPCEagle CLEANTIME 90 Mode D'emploi

This machine has been designed and constructed to provide ten years' service from the
fabrication date shown on the rating plate (fig. 1). After this time, whether the machine
has been used or not, it should be disposed of according to current legislation in the
country in which it is used:
- the machine must be disconnected from the power supply, emptied of liquids and
cleaned;
- the product is classified as WEEE type special waste and is covered by the
requisites of the new environmental protection regulations (2002/96/EC WEEE). It
must be disposed of separately from ordinary waste in compliance with current
legislation and standards.
Alternatively the machine must be returned to the Manufacturer for a complete overhaul.
If you decide to stop using the machine, you are recommended to remove the batteries
and dispose of them at an authorised collection centre.
You should also make sure that all parts of the appliance which could represent a hazard,
particularly to children, are made safe.
5.1.

Lifting and transporting the packaged machine

During all lifting operations, make sure the packaged machine is firmly anchored to
The machine, packaged on a wooden pallet by the Manufacturer, must be loaded using
suitable equipment (see EC Directive 2006/42 and subsequent amendments and/or
additions) onto the transporting vehicle. At destination, it must be unloaded using similar
means.
The squeegees are packed in cardboard boxes without pallet.
A fork lift truck must always be used to lift the packaged body of the machine. Handle
with care to avoid knocking or overturning the machine.
5.2.

Checks on delivery

When the carrier delivers the machine, make sure the packaging and machine are both
whole and undamaged. If the machine is damaged, make sure the carrier is aware of the
damage and before accepting the goods, reserve the right (in writing) to request
compensation for the damage.
5.3.

Unpacking

When unpacking the machine, the operator must be provided with the necessary
personal protection devices (gloves, goggles, etc) to limit the risk of accident.
Unpack the machine as follows:
• cut and remove the plastic straps using scissors or nippers;
• remove the cardboard;
ENGLISH
8
Special waste. Do not dispose of with ordinary waste.
5.

HANDLING AND INSTALLATION

IMPORTANT
avoid it tipping up or being accidentally dropped.
Always load/unload lorries in adequately lit areas.
IMPORTANT