Batteries: Removal; Battery Charger (Battery Models); Choosing The Battery Charger; Preparing The Battery Charger - IPCEagle CLEANTIME 90 Mode D'emploi

Mount the batteries on the machine using lifting means suitable for their weight.
The positive and negative poles have different diameters.
5) Referring to the wiring layout shown in the above diagram, connect the battery cable
and bridge terminals to the battery poles.
Arrange the cables as shown in the diagram, tighten the terminals on the poles and
cover with Vaseline.
6) Lower the dirty water drum into its work position and fasten it to the detergent tank;
7) When using the machine, follow the instructions below.

5.5.3. Batteries: removal

When removing the batteries, the operator must be equipped with suitable personal
protection devices (gloves, goggles, overalls, safety shoes, etc) to reduce the risk
of accidents. Make sure the switches on the control panel are in the "0" position
(off) and the machine is turned off. Keep away from naked flames, do not short
circuit the battery poles, do not cause sparks and do not smoke. Proceed as
• disconnect the battery wiring and bridge terminals from the battery poles.
• if necessary, remove the devices fixing the battery to the base of the machine.
• lift the batteries from the compartment using suitable lifting equipment.
5.6.

Battery charger (battery models)

Never allow the batteries to become excessively flat as this could damage them

5.6.1. Choosing the battery charger

Make sure the battery charger is compatible with the batteries to be charged:
− tubular lead batteries: a 24V - 20 A automatic charger is recommended. Consult the
battery charger manufacturer and manual to confirm the choice.
− gel batteries: use a charger specific for this type of battery.

5.6.2. Preparing the battery charger

If you wish to use a battery charger not provided with the machine, you must fit it with the
connector supplied with the machine (see paragraph "Unpacking" of this manual).
To install the connector, proceed as follows:
• remove about 13 mm of protective sheath from the red and black wires of the battery
charger;
• insert the wires into the connector contacts and squeeze them forcefully with suitable
pliers;
• respect the polarity (red wire + black wire –) when inserting the wires into the
connector.
IMPORTANT
! DANGER
follows:
IMPORTANT
irreparably.
ENGLISH
11