Detergents - Instructions - IPCEagle CLEANTIME 90 Mode D'emploi

Use of abrasive/microfibre disks: fit the abrasive/microfibre disk on the drive disk and
perform the operations described for fitting the brush on the scrubber drier.
Removing the brush (one-brush models) (or drive disk):
Raise the machine head by pushing the head lift pedal down and then to the right (fig. 6,
ref. 9) and repeatedly action the brush/drive lever. After a few pulses, the brush/es (or
drive disk) is released and falls to the ground.
Automatic brush attachment (CT70 ECS, CT40 BT60 ECS models):
place the disks under the head, making sure they rest against the stops to align them with
the attachment device, then press the brush button (fig. 6, ref. 3). The machine performs
the automatic attachment manoeuvre.
Automatic brush release (CT70 ECS, CT40 BT60 ECS models):
turn off all devices (brushes, suction motor), then hold the brush/microfibre release button
(fig. 6, ref. 19) down for at least 5 seconds. The machine performs the automatic brush
release manoeuvre.
! DANGER
These operations must be performed with the machine off.
Fitting the brushes (two-brush models except the CT70 ECS, CT40 BT60 ECS):
Place the brushes under the head drive disk.
Lift the right brush with your hands and turn it clockwise, locking it in position on the drive
disk. Lift the left brush with your hands and turn it anticlockwise, locking it in position on
the drive disk.
Use of abrasive disks: fit the abrasive disk on the drive disk and perform the operations
described for fitting the brush on the scrubber drier.
Removing the brushes (two-brush models except the CT70 ECS, CT40 BT60 ECS):
Raise the machine head by pushing the head lift pedal down and then to the right (fig. 6,
ref. 9). Turn the right brush anticlockwise, releasing it from the drive disk. Turn the left
brush clockwise, releasing it from the drive disk.
Attaching the brush rollers:
lift the head by pressing the head lowering/raising pedal (fig. 6, ref. 9) and fit the rollers in
their housing (fig. 16), first inserting them on the drive pulley and then pushing them
upwards until they click into place.
Removing the brush rollers:
Head lowering/raising pedal (fig. 6, ref. 9): release the brushes by pulling them
downwards from the side opposite the drive pulley, then extracting them from their
housing.
6.5. Detergents – Instructions
IMPORTANT
Always dilute the detergent according to the manufacturer's instructions. Do not
use sodium hypochlorite (bleach) or other oxidants, particularly in strong
concentrations. Do not use solvents or hydrocarbons. The temperature of the
water and detergent must not exceed the maximum indicated in the technical
specification. They must be free of sand and/or other impurities.
The machine has been designed for use with low-foam biodegradable detergents made
specifically for scrubber driers.
For a complete and up-to-date list of the detergents and chemicals available, contact the
Manufacturer.
Use products suitable for the floor and dirt to be removed only.
ENGLISH
15