Auto Shut-Off - Russell Hobbs 18016-56 TIMER PRUNE Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
31 If left for much more than an hour, chemical changes in the coffee liquor start to
affect the flavour. It's best to pour it away and make a fresh pot.
finished?
32 Press the 2 button.
33 The 2 light will go off.
34 Unplug, and let the appliance and carafe cool down fully before cleaning, or for
about 10 minutes before refilling.
warning
Raising the lid before the coffee maker has cooled down may release steam,
creating a scald hazard.
auto shut-off
35 About 2 hours after brewing, the coffee maker will shut down. The hotplate will go
off, the 2 light will go off, and "ON" will disappear from the display.
brew strength e
36 Use this feature if you're brewing less than 5 cups of coffee. It slows the brewing
process, so your coffee will have the same strength as coffee from a full carafe.
37 You may press the brew strength button
to activate or deactivate the brew strength feature.
e
38 Press the
button to activate the brew strength feature, the
up on the display.
e
39 Press the
button to deactivate the brew strength feature, the
disappear from the display.
coffee later
40 Check that the 2 light is off. If it isn't, press the 2 button to turn it off.
41 Initially, the display will show AM, and 12:00 will be flashing.
42 Set the clock to the correct time.
43 The display will show AM for morning, and PM for afternoon.
a) Press and release the h button until the correct hour is shown
b) Press and release the m button until the correct minute is shown
, If you overshoot, you can't step back. Either go right round (24 hours or 60 minutes),
or unplug the coffee maker, to reset the display to 12:00.
44 The clock will retain its settings until the coffee maker is unplugged. It will reset to
12:00 next time you plug it in.
45 Set the timer to the time you want to start brewing.
46 Press the PROGRAM button.
47 "PROGRAM" will flash on the display.
a) Press and release the h button until the correct hour is shown
b) Press and release the m button until the correct minute is shown
, If you don't press either the h or m buttons within 5 seconds, the coffee maker will
revert to "normal", and the time will show. You'll have to press the PROGRAM
button, and start again.
48 Press the v button.
49 The v light will come on, and "AUTO" will show on the display.
e
before or during the brewing process,
41
e
icon will show
e
icon will

Publicité

Table des Matières
loading

Table des Matières