Mounting A (New) Hard Disk - Eminent EM6104 Mode D'emploi

4. Open the App.
5. Press 'Device'.
6. Press 'Add'.
7. Fill out a device name at the 'device name' field. For Example: 'Surveillance
recorder'.
8. Fill out the IP-Address at the 'IP' field. If you are using the 'DVR' App locally, you
need to fill out the local IP-Address of the surveillance recorder. If you want to
access the surveillance recorder externally (using the internet), you need to fill out
the (Internet) WAN IP-Address of the location the surveillance recorder is located.
9. Fill out the 'Media port' number at the 'Media Port' field.
10. Fill out the 'Web port' number at the 'Web Port' field.
11. Fill out the surveillance recorder's Administrator username if you want to login as
an Administrator at the 'UserName' field. Fill out the surveillance recorder's User
username if you want to login as an normal user at the 'UserName' field.
12. Fill out the surveillance recorder's Administrator password if you want to login as
an Administrator at the 'password' field. Fill out the surveillance recorder's User
password if you want to login as an normal user at the 'password' field.
13. Set the amount of channels (camera connections) your surveillance recorder has.
14. Press the 'Save' button to save your configuration.
15. A settings overview appears with the name you have given at step 7. Press this
name to view the camera's image.
16. Use the function buttons on the screen of your smartphone or tablet to start
recording images. Use the PTZ (if a PTZ camera is connected) functions to control
your PTZ camera.

13.0 Mounting a (new) hard disk

Some surveillance recorder kits are equipped with a hard disk, which should provide
enough storage capacity. But it can occur you want to replace the supplied hard disk
for a hard disk with a larger capacity. Also, some surveillance recorders are not
equipped with an internal hard disk which means you need to mount a hard disk. For
both scenarios, you can use the following steps:
1. Make sure the surveillance recorder is disconnected from the power grid and all
other cables are disconnected.
2. Remove the screws from the side of the casing. Also, you need to remove the
screws at the backside and side, which are holding the casing on its place.
3. Carefully lift the cover upwards.
4. You will now see the original hard disk if your surveillance recorder was supplied
with an internal hard disk. Remove the SATA cables form the hard disk and
remove the hard disk en remove the screws from the hard disk and then remove
the hard disk. If your surveillance recorder was not supplied with an internal hard
disk, you will see four mounting holes for an internal hard disk. Connect the new
hard disk using the SATA cables and carefully place the hard disk in the
26 |
ENGLISH