Connecting A Ptz Camera; Setting Up The Surveillance Recorder For Ptz Usage - Eminent EM6104 Mode D'emploi

6.3 Connecting a PTZ camera

It is also possible to connect a PTZ (Pan Tilt Zoom) camera to the DVR such as the
EM6029 Zoom Camera 30X Indoor (not included). Use the following steps to connect
a PTZ camera to the surveillance recorder.
Note: Make sure the surveillance recorder is not connected to the power grid
anymore. Please remove the power plug from the wall outlet first!
1. Connect a video cable (BNC) to the 'Video-Out' connection of the camera.
2. Connect the other end of the video cable (BNC) to one of the 'Video-In'
connections of the surveillance recorder.
3. Take a UTP network cable (For example: The Eminent EM6062) and remove 5cm
of the mantle of both ends of the cable. You need to make sure the bare UTP
wires are exposed.
4. Now strip the cable at both ends. Make sure you maintain about 5mm of bare
copper.
In the following steps, we have stripped the following UTP wires: Blue and blue-white.
5. Connect the blue UTP wire to the '485A' connection of the surveillance recorder.
6. Connect the blue-white UTP wire to the '485B' connection of the surveillance
recorder.
7. Check whether you have connected the wires properly to the surveillance
recorder.
8. Connect the blue UTP wire to the '485A' connection of the PTZ camera.
9. Connect the blue-white UTP wire to the '485B' connection of the PTZ camera.
10. Check whether you have connected the wires properly to the surveillance
recorder.
11. Connect the power cable of the power supply. For example: the EM6060 (not
included) to the 12V connection of the camera. You can also use the EM6160
Power supply (not included) with splitter to which you can connect up-to eight
camera's.
12. Reconnect the power cable of the surveillance recorder to the wall outlet again,
after which the surveillance recorder starts.

6.4 Setting up the surveillance recorder for PTZ usage

1. Make sure the surveillance recorder is completely started, and you can see the
surveillance recorder's image on your screen.
2. Click 'Start'
3. Fill out the password you have set during the wizard and click 'Login' or do not fill
out a password if you have not used the wizard or if you do not have set a
password and click 'Login'.
4. Click 'Advanced'.
5. Click 'P.T.Z.'.
12 |
ENGLISH