Manual Settings; Setting Up Passwords; Setting Up A User Account - Eminent EM6104 Mode D'emploi

8 |
ENGLISH
select the frame rate (amount of images shown per second). '25' is the highest frame
rate possible (but depends on the amount of channels and chosen resolution). 25
frames per second delivers images which are shown as fluently as possible. The lower
the frame rate, the less fluently the recorded image will appear. A higher frame rate
will consume more hard disk space.
At 'Quality', you can select the quality of the image. Setting the quality to 'Best', means
the quality is as good as possible. However, setting a higher quality also means more
hard disk space will be used. Click 'Next'.
Step 8:
At the following screen, you can see the status of the internal hard disk and the
capacity of the internal hard disk. At 'Overwrite', you can select the 'by capacity'
option, which means the oldest recorded files will be overwritten when the hard disk
reaches its maximum capacity.
If you want the files to be overwritten after a preset amount of days, select 'by days'
and set the amount of days.
Place a mark at 'Format' and then click 'Format' to begin formatting the internal hard
disk. Please be patient while the hard disk is being formatted. Click 'Save'
Step 9:
Click 'OK' to finish the setup wizard.

5.0 Manual settings

If you have not used the setup wizard, or you want to manually setup a password to
prevent third parties to gain access, or you want to manually set the date and time,
you can manually set the surveillance recorder. And, if your surveillance recorder has
been connected to your network, you can manually set the IP address data.

5.1 Setting up passwords

In order to prevent third parties gaining access to the settings of the surveillance
recorder, you can setup a password in the surveillance recorder. There are two
different types of accounts which can be used to setup a password. A user account
with a password and an admin account with a password. A user account is supposed
to be used for the 'normal' user which can only view images and can not alter any
settings. If needed, you can also create a user account and add privileges you want to
add for this user account.
An admin account is supposed to be used for the person who is able to view and alter
all settings.

5.1.1 Setting up a user account

1. Make sure the surveillance recorder is completely started, and you can see the
surveillance recorder's image on your screen.
2. Click 'Start'.
3. Fill out the password you have set during the wizard and click 'Login' or do not fill