Waring Commercial THE BIG FREEZE Mode D'emploi page 5

INTRODUCTION
The Big Freeze
soft ice cream, gelato and custard-based mixtures in standard
milkshake cups, utilizing a powerful and quiet, direct-drive motor
without noise-producing gears or belts.
SPLASH SHIELD ASSEMBLY
1. Position the main housing on a sturdy surface where it will
not be knocked over.
2. Remove the splash shield guide track (part 8) from the
right side of the main housing by removing the two thumb
screws.
3. Locate the splash shield (part 7).
4. Slide the splash shied into the guide track on the left side
from top to bottom so that it rests on the bottom.
5. Take the right guide track and slide it over the splash shield
from top to bottom.
6. Reassemble the right guide track to the main housing by
aligning the thumb screws with the openings at the top
and bottom. Make sure that the thumb screws are screwed
in securely.
7. Be sure that the splash shield slides up and down freely
*Note that the splash shield is meant to be secured to the housing
to ensure safe operation.
OPERATION
1. Be sure the plastic splash shield has been properly installed
and slides up and down freely.
2. Select and install the appropriate-style agitator based on
the use of either hard or soft drink bases, by loosening the
screw located under agitator with a screwdriver. Change
agitators simply by securely holding the spindle while
rotating agitator counterclockwise and tighten screw with
a screwdriver.
3. Ensure drink mixer is placed on a secure, flat surface that is
able to withstand the unit's weight.
4. Plug power cord into properly grounded electrical outlet of
correct voltage.
drink mixer is designed to process both hard and
™
5