Geemarc CLEARSOUND CL2L Manuel D'instructions page 8

BELL PUSH
3.2. CHANGE THE BATTERY
The door bell is supplied with a 23A 12V battery. The
CL2 is supplied ready to use, it is not necessary to open
the bell push when you first install the CL2.
To replace the battery, open the access cover and
unscrew the door bell from the wall, unscrew the three
screws located on the base and open the box to get
access to the battery compartment. Replace the battery,
replace back and remount.
Back of Bell Push
Note: Do not use a rechargeable battery. Do not put the
used battery into the household rubbish, pay attention to
battery regulations regarding battery disposal.
CHANGE THE BATTERY
Unscrew to
open
7
Inside Bell Push
Battery
Switches for
LED colour