Wall Mounting - Geemarc CLEARSOUND CL2L Manuel D'instructions

BELL PUSH

WALL MOUNTING

3.1. BELL PUSH – WALL MOUNTING
The wire free bell push is mounted by the front door. It
has a range of 20-60 metres depending on the structure
of the building (see note).
Test the system before mounting
on the wall – plug in the CL2 and
press the bell push button to
check that the CL2 rings.
To mount the bell push, open
the access cover in the middle of
the bell push with a needle or
small screwdriver.
Decide where to position the bell
push and use the wall mount
template, shown below, to mark
the holes on the wall or door
surround and drill holes if
necessary.
Align with prepared marks or screwholes, insert and
tighten screws and replace access cover.
Bell push is now ready for use.
Note: Do not place the bell push onto a metallic base or
near electric equipment (such as TV, Radio, computer,
washing machine...). The CL2 will work within a range of
60m in an environment where there are no obstacles
and 20m in an environment which contains a wall or
metallic structure.
5