Geemarc CLEARSOUND CL2L Manuel D'instructions page 11

PAIRING
4.2. The Pairing Procedure
( Note : Factory default setting : paired. )
1. Press and hold the
seconds to enter pairing mode, at the same time, the
unit makes a beep sound.
2. The 1st LED lights, to pair the BELL PUSH, press and
hold the
push button at the same time, the 1st LED flashes,
after paired, the 1st LED lights and stop flashing,
beeps to confirm.
3. If user wants to pair the 2nd or 3rd BELL PUSH, when
the 1st LED lights, press the
button within 2 seconds, the 1st LED goes off and
then the 2nd LED lights. User is able to pair the 2nd
BELL PUSH, repeat the same procedure for the 3rd.
4. Repeat the above, all 3 LEDS flashing together for the
4th BELL PUSH pairing, the BELL TONE is not
adjustable for the 4th BELL PUSH.
5. If paired more BELL PUSH on same LED, only the
last one kept.
(Pairing/Test) button for 2
(Pairing/Test) button and then Bell
10
SETTINGS
(Pairing/Test)