Taking Into Service; Before Assembling; Choosing The Location - Kröber OXYDERME THBO Manuel D'utilisation

6. Taking into service

6.1 Before assembling

Check before assembling whether all components needed for correct opera-
tion are available.
NOTE!
Contact the manufacturer or the local service provider if help is needed
during operation or maintenance. The address of the manufacturer can be
found on chapter 1.6. The address of the manufacturer should have
been disclosed during initial training on the device.
Box content:
- Oxyderme THBO concentrator by Kröber unit.
- User manual
- Coarse dust filter.
- Fire safe check valves.
- Oxygen safety hose 15m.
- Oxygen safety hose 0.33m.

6.2 Choosing the location

Please consider the following when choosing the location:
- The unit should have 30cm clearance from any walls, curtains and other
large objects (e.g. cupboards), to ensure unrestricted entry of air through
the back of the unit.
- The unit is air cooled. It must therefore not be placed near heaters, etc. At
such a location there is a risk of overheating.
- The unitshould be operated only in places where it is not impaired by air
pollution or smoke.
NOTE!
The unit can be safely lifted and moved by the carrier handle on top of the
unit.
ATTENTION! Ensure a sufficient air supply!
Ensure that the air inlet of the Oxyderme THBO oxygen concentrator by
Kröber is located in a well-vented spot.
The Oxyderme THBO oxygen concentrator by Kröber must not be operated
directly next to or even stacked with other equipment. Ensure a sufficient
distance from the walls, etc.!
14
Oxyderme THBO