Returning Calls - Tait T2030II Guide De L'utilisateur

Callback
Redial
Call Queuing
II
(T2035 only)
14
English

Returning Calls

Use the memory features described below to re-
establish earlier calls and return unanswered calls.
When an incoming call finishes, your radio stores the
caller's number. The CALLBACK indicator glows in the
II
T2030 , and the caller's preset number or ID flashes on
the display of the T2035
To return the call, press the Callback (
II
(T2030 ), or the Call (
the GO indicator to light, and proceed as usual.
You may also be able to initiate a callback by squeezing
the PTT key briefly (depending on how your radio is
programmed).
The last number you called is also stored in your radio's
memory. To call that number again, press the PTT key.
If your radio is in callback mode, press the Clear (
key to discard the callback ID before redialling.
II
Your T2035 may be programmed to queue up to 20
unanswered call IDs.
To access the queue, press the Queue (
hold the Despatcher (
second. The QUEUE indicator will light. Press the
Despatcher (
In queue mode, press the Queue key to scroll through
the list of IDs. When you reach the end of the list, the
radio will beep and reverse the scrolling direction.
To return a call to any of the listed IDs, press the PTT
key or the Call (
delete an ID from the list, press the Clear (
II
.
) key (T2035
) key for approximately one
) key again to leave the queue.
) key when that ID is displayed. To
) key
II
). Wait for
)
) key and
) key.