Unpacking; Disposal Of The Packaging; Installation Of The Appliance; Requirements For The Installation - CASO DESIGN EMGS 25 Mode D'emploi Original

 4 screws and bracket for installation
 operating instructions
Please note
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.

13.3 Unpacking

To unpack the device, proceed as follows:
 Remove all packaging and accessories.
 Check the appliance for possible damages (dents, damaged door etc.). Damaged
appliances may not be used.
 Casing: Remove the protective film covering the outside surface of the appliance.
 The light brown/silver cover in the interior of the appliance protects the magnetron
and must not be removed.

13.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and
reduces the quantities of accumulated waste. Take any packaging materials that
are no longer required to "Green Dot" recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

13.5 Installation of the appliance

13.5.1 Requirements for the installation:

 Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 Ensure that the power cable does not hang down over a table or counter edge.
 The installation and assembly of this device in non-stationary setup locations (e.g.
on ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
caso EMGS 25
 suction cup
51